Hardtop Depot PRE-INSTALLATION INSTRUCTIONS

Hardtop Type: Hardtops
Truck Model: Jeep

General Safety Information:

Instructions – Safety

Your hardtop will come with all the necessary parts to complete your installation. To safely lift and install this hardtop, you will need the assistance of at least one other person. The following instructions are examples of the installation. Please follow the instructions that are included with your hardtop.

REMEMBER: It is the owner’s responsibility to insure proper installation and perform monthly maintenance checks of fasteners. Doing so will assure safe operation and long life of your upper hard doors.

Instructions – Warning

WARNING: The top on this vehicle is designed only for additional protection against the elements. Do not rely on the top to contain occupants within the vehicle or to protect against intrusion of foreign objects, nor injury during an accident. Make sure all brackets and screws are tight. Periodically check for tightness and retighten when necessary. Wear seat belts at all times.

Instructions:

Follow the instructions and perform the steps in the sequence given. Shortcuts to the directions may result in an unsatisfactory installation.

1. Place your tape on top ledge of the windshield.

2. Extent the tape to the rear of the body.

3. Where the tape hits the body , it should read the value in the chart below. Measure both sides. If it does, put the top on. If not, go to step 4.

  • CJ 5 (1972-1975) — 70 3/4”
  • CJ 5 (1976-1983) — 67 1/4 “
  • CJ 7 & YJ — 75 1/8”
  • CJ 8 — 97 11/16”
  • TJ — 75 1/8”
  • Unlimited — 89 7/16”

4a. CJ 5 Loosen the bolts and wing nut. Adjust windshield and tighten.

4b. CJ7 – CJ 8 – YJ Loosen bolts using a T40 torx wrench. Go to step 5.

4c. TJ & Unlimited Using a T40 Torx wrench, loosen the bolt above the doors hinge. Go to step 5.

5. Using a T50 tamper resistant Torx wrench or vise-grips, loosen this bolt. On the CJ 7 & YJ’s it’s on the top of the roll bar. On the TJ & Unlimited it’s on the side of the roll bar. This will be a 2 person job. One checks the measurement, the other person tightens the bolt. Remember 75 1/8” on both sides. (Unlimited 89 7/16”). Once this is accomplished, tighten up the bolt you loosened in step 4. Now you can put your top on. If the windshield is properly adjusted, the space between the windshield and the door should be the same on both sides.

Need more help?

Installing your hardtop sport truck hardtop is a simple process, but we are always ready to lend expert advice.

Contact Us